A pipe usually fails inside a wall cavity, which means the visible damage is only a fraction of what's actually happening behind the drywall.
Insulation and drywall removal is targeted, and we coordinate directly with a licensed plumber for the actual pipe repair.
Stopping the water source is priority one before any extraction begins.
We use pressure testing and moisture tracing to locate exactly where a supply line failed inside the wall.
We open wall cavities in a controlled, targeted way based on documented moisture data.
Handoff to a licensed plumber is built into our burst pipe process, not left for you to arrange separately.
Below is what happens on a typical Burst Pipe Water Damage call in Kensington, CA.
Stopping active water flow happens before any cleanup step.
Pressure testing and moisture tracing help pinpoint exactly where the line failed.
Wall cavity extraction addresses moisture a surface-level approach would miss.
Saturated insulation is removed and replaced, while drywall is cut only at the confirmed wet line.
We dry wall framing directly, not just the room's ambient air.
Plumbing repair coordination is included so you're not managing two separate contractors.
Tell our Kensington, CA dispatcher if the water source is still running so we can advise on shutoff immediately.
Our nearest crew arrives ready to confirm shutoff and begin diagnostics.
You'll see the scope and cost once the failure point is confirmed.
We verify wall cavity moisture readings hit dry standard and confirm plumber repair is scheduled before closing the file.
"They found our shutoff valve in about thirty seconds since we had no idea it existed, then got straight to work on the wall." — Holly T.
"Only opened up the section of wall that was actually wet instead of the whole thing. Saved us a lot on drywall repair." — Andre L.
"They coordinated directly with our plumber so the pipe got fixed the same week the wall was already open." — Priscilla W.
We can confirm which you're dealing with during the initial assessment.
No, we remove drywall only at the confirmed wet line based on moisture readings.
We can refer a plumber or work alongside yours to keep the timeline aligned.
Turning off the water source, if accessible, limits damage before we arrive.
Most burst pipe jobs dry out within about a week, similar to other structural drying timelines.
If your address is in or near Kensington, a crew can typically respond the same day.
One call gets a Kensington, CA crew routed to Kensington with the right equipment.
Call +1-844-833-1325